Roof Question

[DOOM]

Hey guy's ..... I was just chopping away at the Camaro today ,removing the roof . What holds the roof to the drip rail :question:

[dhutton]

About 1000 spot welds. :D I found the easiest way to remove it was to grind through the spot welds with a cutting disc.

Don

[greycamaro]

doing the same at the moment doom. please let me know how that works out.
alex

[Autokraft]

Mario, like Don said alot of spotwelds along the driprail, grind off with a die grinder.Just try to be careful u dont grind through the driprail:thumbsup:

[redfire69]

Yep, this is one spot where more rust helps out. My drip rails were shot so off they went too. It's easier to cut the roof off an inch or so back, then you can find and dispense with the spot welds. Good luck!

[DOOM]

Thanx Guy's!! I'll get to grinding..:faint:

[Bow Tie 67]

It's like they used some type of rolling spot welder. Grind through most of each spot weld and then peel off the edge of the roof. It helps if you cut the roof as close to the drip rail as possible. Tedious but not hard. :thumbsup: