Best place for sheet metal

[Mikamaro]

Don't need much, center of trunk, front and rear drivers side floor patch, passenger fender extension.

I see alot of people say AMD is good, but they only have the full trunk pan, don't need it, too expensive. Also they don't sell the just the rear RS floor patch, or the fender extension seperately. I was looking at Year One, Rick's 1st Gen, Classic Industries... Year One is the only one that lists the panel gauge so I can't compare one vendor to the other.

Please advise oh experienced ones :hail:

Mike

[elitecustombody]

AMD , :lol:

had to, sorry man, if all you want is patches, I doubt it will make much difference where you get it from,find the best deal and get it done,though AMD is hands down the best aftermarket metal, it would be a waste buying it for patches. Good luck.