bulkhead fittings -10

[RickM415]

so where do i get some hose ends to go to the o-ring -10 on the firewall to my water pump inlet and outlet

i am wondering what type of fitting should i have on my water pump and what size

[camcojb]

do you have pics of what you're working with? Hoses from the pump to the firewall would be heater hoses. The LS pumps have pressed in nipple fittings on the pumps. I remove those and tap them for pipe threads (one is 1/2" NPT and the other is 3/8" NPT). Then I can use a pipe to #10 AN fitting and run my #10 heater hoses to the firewall. I'm confused by the 0-ring fitting you mentioned, all the firewall bulkhead heater hose fittings I've used have had normal male AN ends on them, so any #10 AN hose end would work. The A/C fittings are 0-ring #6 and #10 (others sizes optional) but not the water fittings.

Jody

[RickM415]

http://www.oldairproducts.com/catalog/popup_image.php?pID=3598

ok i got this from detroit speed /vintage air and it looks like all of them are 0-ring on both sides 3 -10 and 1 -06

[camcojb]

http://www.oldairproducts.com/catalog/popup_image.php?pID=3598

ok i got this from detroit speed /vintage air and it looks like all of them are 0-ring on both sides 3 -10 and 1 -06
yeah Vintage Air gives you AN fittings for the heater hoses. If you go to Old Air's site they sell the heater hose ends, they look just like a/c fittings............. Would have to be crimped onto the hose and you'd be using a non-braided type hose.

Jody

[RickM415]

thank you Jody