windshield problems please help!!!!

[sixnina]

First of all thanks in advance to those who respond. I have been working on my 69 camaro for the last 3 years putting it together as money permits. Recently tried to have glass guy install windshield, as the car did not have one when i aquired it. Problems arose when new windshield was set in place and on the drivers side it contours to dash well. Glass guy told me window has to lay flat along window channel because it gets glued down like on newer cars. This is where the problem begins because on passenger side the windshield sits about 3/8 -1/2" off the dash and window channel. i buzzed down the dash to find a small amount of filler and that helped to bring the windshield closer but i can still fit my finger under the corner. Has any one ever ran into this? can dash be adjusted or is it welded in? Any help is greatly appreciated. Thanks, Shane

[elitecustombody]

does it bulge out and won't sit flush or it's too short on the bottom corner? Hvae you measured the glass to make sure it has proper dimensions?

[sixnina]

it bulges out and wont sit flush. does anyone have the dimensions a 69 camaro glass should be? Its brand new via the glass guy.

[elitecustombody]

What brand is the glass from?Do you have the old glass? I'd compare them both,but it almost sounds like you have alot of filler

[sixnina]

not sure what brand but will check. the dash had a little filler but i buzzed it down to bare metal and still had issues. Unfortunately i never had the original glass so nothing to compare it to.