FS: New Moser Ford 9" 33 Spline Complete

[Ron in SoCal]

Brand new Moser For 9" Rear end:
33 Spline Axles
Fill plug installed by Moser
Flush mount drain plug installed by Moser
Detroit True Track
Aluminum cover, 325 Grear

This came with project car I bought and am going with a narrow Moser Ford 9, so I'm selling this one. It was purchased a few months ago, was brand new/never run and has only been mounted on the car and sat in the garage. It will be shipped from Indy. I have a rceipt from Moser and retail on this set up was $2773. I'll let it go for $2100 or best reasonable offer, plus shipping.

Feel free to email or PM from this site. Thanks!

Ron

[boonedog]

whats the width backing plate to backing plate?

[Ron in SoCal]

I'll need to measure it to confirm later today, but the paperwork says 54 1/4...

[Travis77]

would you consider any trades?

[Ron in SoCal]

would you consider any trades?

Depends on what you've got! Inbox is cleared...

Ron

[70 chevelle]

Application?

[Ron in SoCal]

This came off a 69 Camaro w the GW Cat 5 leaf s-u....

Ron

[sacarguy]

Does it have chevy or ford bolt pattern on the axcles what brakes etc ?

[Ron in SoCal]

Does it have chevy or ford bolt pattern on the axcles what brakes etc ?

Chevy bolt pattern. 5 x 4.75, no brakes come with it. I do have a brand new set of Wilwoods 13" slotted rotor 6 pot front / 12.19 slotted rotor, 4 pot rears that came with this car I could package up, but I was planning on putting that into another FS thread...

Ron

[boonedog]

were is this located? Pics?

[94snglturbo]

ok just let me know if it falls through