CreepinDeth
03-13-2010, 04:51 PM
Guys, I'm kinda stuck here and I'm hoping SOMEONE might have the proper wiring Diagram or info for these wires.
I've been googling my ass off to no avail. NONE of the wiring diagrams out there match what I have on my 16 pin
connector. Yes, I've seen the one's on 12Volt.com and you'll notice my wiring doesn't match the one's they posted,
OR any other one's online. Any GM Service techs maybe that know what goes where......
This mirror came out of a 2004'ish Saturn Vue.
It's a Gentex 015607, Autodim, Compass, Temp Display mirror.
It has a 16 pin connector on the back side. Only 5 wires are attached.
I'm not sure which is PIN #1, so I'll just describe what I see.
I am hoping for a wiring diagram or help on where the 5 wires get connected to for
power and service.to get all 3 features functioning properly.
Looking at the mirror from the rear. As shown in attached pic.
I have TOP ROW - Left to Right
PIN #1 = Black [Pretty sure this is ground]
PIN #2 = Gray / Black stripe [no clue]
PIN #3 = Lite Green / Black stripe [Temp sensor probe?? Should be 2 wires tho....]
PIN #4, 5, 6, 7, 8 = empty.
BOTTOM ROW
PIN #1, 2, 3 = Empty
PIN #4 = Yellow [12V switched ??]
PIN #5, 6, 7 = Empty
PIN #8 = Lite Green[ Reverse Dim Inhibit?? ]
http://i46.photobucket.com/albums/f122/Aceshigh22/LS1%20Implant/Gentex015607MirrorREAR800x600.jpg
http://i46.photobucket.com/albums/f122/Aceshigh22/LS1%20Implant/Gentex015607MirrorFRONT800x600.jpg
I've been googling my ass off to no avail. NONE of the wiring diagrams out there match what I have on my 16 pin
connector. Yes, I've seen the one's on 12Volt.com and you'll notice my wiring doesn't match the one's they posted,
OR any other one's online. Any GM Service techs maybe that know what goes where......
This mirror came out of a 2004'ish Saturn Vue.
It's a Gentex 015607, Autodim, Compass, Temp Display mirror.
It has a 16 pin connector on the back side. Only 5 wires are attached.
I'm not sure which is PIN #1, so I'll just describe what I see.
I am hoping for a wiring diagram or help on where the 5 wires get connected to for
power and service.to get all 3 features functioning properly.
Looking at the mirror from the rear. As shown in attached pic.
I have TOP ROW - Left to Right
PIN #1 = Black [Pretty sure this is ground]
PIN #2 = Gray / Black stripe [no clue]
PIN #3 = Lite Green / Black stripe [Temp sensor probe?? Should be 2 wires tho....]
PIN #4, 5, 6, 7, 8 = empty.
BOTTOM ROW
PIN #1, 2, 3 = Empty
PIN #4 = Yellow [12V switched ??]
PIN #5, 6, 7 = Empty
PIN #8 = Lite Green[ Reverse Dim Inhibit?? ]
http://i46.photobucket.com/albums/f122/Aceshigh22/LS1%20Implant/Gentex015607MirrorREAR800x600.jpg
http://i46.photobucket.com/albums/f122/Aceshigh22/LS1%20Implant/Gentex015607MirrorFRONT800x600.jpg