CreepinDeth
08-23-2009, 08:36 PM
PICS PLEASE if you got em. :)
Just trying to figure out where to put my American Autowire Highway 22 kit's
fuse panel and after Googling only came up with 1 thread on the Chevelle's
forum (http://www.chevelles.com/forums/showthread.php?p=2272959), I'm still trying to figure it out. I have a 1978 Camaro, and it's a VERY
tight fit between the kick panel, and the brake pedal, and the wires go in on
the LEFT side unless I mount it upside down.....which I don't really want to do.
http://image.customrodder.com/f/tech/8857199+pinline_medium/0607cr_03_z+down_to_the_wire+.jpg
Someone put the fuse panel in a 1969 Camaro's left kickpanel = no go for me.
Someone put the fuse panel in the trunk of another vehicle = no go because
at least 4 of the wires going to the steering column connector are not nearly
long enough to make it back there to the fuse panel.
So I'm looking for ideas.
I have an LS1 in my car and I'm also trying to debate on where to relocate
the PCM. Right now it's sitting on my passenger fender which is gay. So I
want to relocated it. I was thinking either BEHIND the glove box, OR up in
the front drivers side fender behind the headlights. If I do this, then I can
put the fuse panel behind the glove box. Any other ideas, or pics ??
http://i46.photobucket.com/albums/f122/Aceshigh22/LS1%20Implant/LS1completedLarge.jpg
Just trying to figure out where to put my American Autowire Highway 22 kit's
fuse panel and after Googling only came up with 1 thread on the Chevelle's
forum (http://www.chevelles.com/forums/showthread.php?p=2272959), I'm still trying to figure it out. I have a 1978 Camaro, and it's a VERY
tight fit between the kick panel, and the brake pedal, and the wires go in on
the LEFT side unless I mount it upside down.....which I don't really want to do.
http://image.customrodder.com/f/tech/8857199+pinline_medium/0607cr_03_z+down_to_the_wire+.jpg
Someone put the fuse panel in a 1969 Camaro's left kickpanel = no go for me.
Someone put the fuse panel in the trunk of another vehicle = no go because
at least 4 of the wires going to the steering column connector are not nearly
long enough to make it back there to the fuse panel.
So I'm looking for ideas.
I have an LS1 in my car and I'm also trying to debate on where to relocate
the PCM. Right now it's sitting on my passenger fender which is gay. So I
want to relocated it. I was thinking either BEHIND the glove box, OR up in
the front drivers side fender behind the headlights. If I do this, then I can
put the fuse panel behind the glove box. Any other ideas, or pics ??
http://i46.photobucket.com/albums/f122/Aceshigh22/LS1%20Implant/LS1completedLarge.jpg