View Full Version : Toe conversion from degrees to inches
gearheads78
05-25-2009, 05:28 PM
I aligned my car today and the camber and caster dead on to the specs that came from my SC&C instructions. The toe said to set -1/16" but our alignment rack does not measure inches . I guessed and set -.30 degrees each side but I was wondering if there is a conversion.
Roadbuster
05-25-2009, 07:33 PM
I had mine done for a 1/16 inch total or 1/32 inch per side and it was 0.07 degrees on the left and 0.06 degrees on the right.
Jon
Musclerodz
05-26-2009, 12:14 AM
I aligned my car today and the camber and caster dead on to the specs that came from my SC&C instructions. The toe said to set -1/16" but our alignment rack does not measure inches . I guessed and set -.30 degrees each side but I was wondering if there is a conversion.
1/16" is .0625
David Pozzi
05-26-2009, 01:27 AM
Here's a handy toe chart. Numbers are for ONE wheel.
http://www.smartracingproducts.com/pdfdocs/toe_settings.pdf
Roadbuster
05-26-2009, 02:54 AM
Here's a handy toe chart. Numbers are for ONE wheel.
http://www.smartracingproducts.com/pdfdocs/toe_settings.pdf
Thank you David, I will be saving that!
Jon
gearheads78
05-26-2009, 12:12 PM
1/16" is .0625
Not talking a measurement. I am talking degrees of rotation.
Here's a handy toe chart. Numbers are for ONE wheel.
http://www.smartracingproducts.com/pdfdocs/toe_settings.pdf
Thanks ...exactly what I was looking for:bow:
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.