what does happen when a car yanks 3 wheels from the launch!?

[racebuicks]

http://www.youtube.com/watch?v=4g75YmRZbYw

[enzo]

ummm ?

[XLexusTech]

Uuuummm X2 it may be fun but it sure looks scary :thumbsup:

[racebuicks]

It wasnt fun at all. had to learn to drive for sure. A couple of times I about crapped the old drawers. And yea all thats been fixed. its an old vid. I installed a anti roll bar on the rear suspension. It makes the car go up even about 6 inches off the line and no more of that 3 wheels in the air crap. This is the motor that made 826 hp and 801 lbs of torque that I posted the dyno vid of.

[SS1156]

How much cage do you have in the car? We have a 66 Chevelle drag radial car that has a 708 w/ 3 stages of nos and we have had to add bars in the car so it doesn't do that. I think your car has a little too much flex to it. I know it sounds like the car is too stiff but it's not. Have you tried asking this question over on Yellow Bullet?

[racebuicks]

it only has a 10 point in it. The car may have been too loose but I had to fix multiple problems. I had bad shocks bad springs bad set up all around. These runs were taped right after I went from a 600 hp set up to an 800 hp set up. I figured (until I figured out I was wrong) that the chassis would hold the extra power...boy was I wrong.......... The car has had alot of work done to the chassis since then. Its working gooooooood now. well except the broken crank thing.:willy: