Using aftermarket Hydraulic Thowout bearing

[JamesJ]

I remember reading that someone made an adapter or maybe a new hose to be used when using the factory hydraulic clutch master with an aftermarket hydraulic throwout bearing such as a McLeod unit. I think that it replaced the quick connect with and AN fitting. Does anyone remember this? Or know where to get something that will work?

[1 Dwn Cam]

What is your setup? LS motor and LS T-56?

[Tiger]

I was planning to use a T5 bellhousing with the attached slave so I cut the quick connect and silver welded an AN to it.
never got around to use it but its a way of doing it.

[JamesJ]

What is your setup? LS motor and LS T-56?

LT-T56 with a SBC

I was planning to use a T5 bellhousing with the attached slave so I cut the quick connect and silver welded an AN to it.
never got around to use it but its a way of doing it.

Thats what I will do if I cant find this... I think it may have been a new hose that has has the AN fitting already installed.