*rayman*
08-21-2008, 03:31 PM
How many of you guys have had problems with a stuck door during the assembly part?
I have new latches, new strikers, new exterior handles, new lock barrels, nice tight hinges, new rubbers installed.
LH Door works like a treat, and closes firmly. (did originally have problems here with door buinding shut, until i replaced worn striker and door latch mech)
I have spent countless hours playing with the RH door, but it will close, and get stuck closed. I can release the latch by putting a small flatblade screwdriver into the latch and overriding the latch.... Latches have been lubed up with white lithium grease, and work fine out of the car.
This is so frustrating, i just want to get it back together and get the interior finished off.
I've read through a lot of posts on camaros.net and there seems to be heaps of guys have encountered the problem there... most with worn door mechs though....
I have new latches, new strikers, new exterior handles, new lock barrels, nice tight hinges, new rubbers installed.
LH Door works like a treat, and closes firmly. (did originally have problems here with door buinding shut, until i replaced worn striker and door latch mech)
I have spent countless hours playing with the RH door, but it will close, and get stuck closed. I can release the latch by putting a small flatblade screwdriver into the latch and overriding the latch.... Latches have been lubed up with white lithium grease, and work fine out of the car.
This is so frustrating, i just want to get it back together and get the interior finished off.
I've read through a lot of posts on camaros.net and there seems to be heaps of guys have encountered the problem there... most with worn door mechs though....