Does Anyone Have a DXF for an L92 Intake Interface?

[badmatt]

does any one have this that there willing to share so I can make a set of intake flanges?

[badmatt]

annnnnnnnnnnnnnnnnny one?

[badmatt]

well this sucks.......

[ccracin]

I'll bet 90+% of the people reading this don't know what a DXF is. Since that is the case, I think you have a small group from which to pull this information. I have also found that as helpful as folks are in this industry, they draw the line (lol) at drawings and especially models. I tried to get drawings or models of components I purchased so that could finish my drawings and models. No dice. I wasn't looking for manufacturing detail, but it didn't matter. I wish you luck.

Later,

[ironworks]

If you join SEMA or know somebody that is about the only way I know to get that info. Other wise get out the old tape measure and do it the old fashion way. If you have a High tech machine shop they might have a digital arm and could scan it pretty easy. I do that with motor plates and such.

Rodger

[deuce_454]

or you could try lstech....

[badmatt]

Sorry to resurect an old post, but I got the measurement i just broke down and purchased a set of heads...
thanks guys!