PDA

View Full Version : CNC Master Cylinder Resavoir.

1 Dwn Cam
04-07-2008, 01:19 PM
Anybody have a picture of their CNC master cylinder resavoir #1484. I purchased one today and want to see how they look mounted on the firewall. Also do they have a threaded fitting for a AN-4 male feed line?

http://www.cncbrakes.com/acc.asp?grp=acc&subgrp=all&series=rrk&subseries=
1 Dwn Cam
04-09-2008, 08:36 AM
All the bad ass cars on this forum and nobody has one? I find that hard to believe.
1 Dwn Cam
04-09-2008, 03:59 PM
Just got it back from the polishers.
rjsjea
04-09-2008, 04:17 PM
I have the master/clutch cylinders mounted under the dash and have been looking at those to use for a reservoir mounted on the firewall..............not there yet, but I think that will look nice. I also have been lookin at these ones.
1 Dwn Cam
04-09-2008, 10:07 PM
WOW!:wow:Those are way sweet. Who makes those?
rjsjea
04-10-2008, 12:56 PM
www.cvproducts.com part #cvc450. Since I havent bought them yet I would like to know what else is out there......anybody???
tjbruning
04-10-2008, 02:05 PM
www.cvproducts.com part #cvc450. Since I havent bought them yet I would like to know what else is out there......anybody???

rob, I have the printout off cv products website of that very same thing... you have good taste in expensive parts :cool:

tilton makes nice resevoirs also...