lots of camaro resto parts and other parts for misc makes

[sacarguy]

I have the folowing all new some opened or not packaged but new and new condition unless other wise noted
69 camaro package tray vynl - 35 $

69 camaro trunk to interior seperator 15 $

68-69 camaro convertible top boot 45 $

4 sets 69 camaro rs headlight door inner hinges - 30 bucks for a pair

2 69 camaro convertible top wiring harness - 20 $

rs headlight door bumpers 5 $

4 kits 69 console stopers 5 $
69 console ashtray

5 69 light switch 5 $

2 68-69 console hardware kit 5 $

1 69 rs headlight door stop bracket kit 5 $

5 69 camarro rs headlight bushing kits 5 $

1 68-69 rs return spring set 5 $

4 68-69 console lamp lense 5 $

6 16 inch 2900 cfm electric fans with shrouds 165 $ shipped

2 ls2 billet massiar/filter assymblies for rod / conversions 240 $ shipped

1 billet bow tie filter universal for speed density < slips over tbody > 100 shipped

1 chip foose engraved dynalight willwood caliper 150 shipped

1 chip foose engraved superlight willwood caliper 150 shipped

1 69 camaro left hand tail light bucket 20 shipped

4 69 inner door guide felt 5$

5 69 console hinge 10 $

1 willwood superlight caliper standard 75.00 $

1 willwood master cylinder remote or standard resevoire mount 85 $

1 willwood billet master cylinder - sold

1 68-69 camaro doorlock and trunk lock set with keys
1 68-69 door lock set with keys

1 68-69 camaro glove box lock with key

1 68-69 camaro ignition switch with key

1 68-69 camaro glove box lock with key and catch complete

1 90 mm fast ls-1 throttle body CHROMED 295 shipped

1 msd 6 btm 275 shipped < sold >

1 msd 6al 175 shipped sale pending

1 msd plug wire set 8 cylinder multi angle boots universal 75 shipped

1 msd 6al used 125 shipped

1 msd 7530 programable digital 7 used Sold

2 detroit speed rs camaro headlight electric conversion motors 100 shipped 1 sold

1 detroit speed complete rs electric headlight conversion 300 shipped sold

1 roush billet valve covers for ford small block engraved with roushe 427 - R 150 shiped

1 gt350-500 mustang moto lita billet/wood steering wheel 15 inch diameter 150 shipped sold

2 kn extreme air cleaner assemblies # 30-3040 14 inch diameter 3 inch thick 75 shipped sale pending both sold

2 fuel air spark sensor kits < map water air and tps > 75 shipped

2 fuel air spark replacement wide band 02 sensors 150 shiped

1 9 inch currie rear end housing 52 3/4 flange to flange with no brackets on it not able to ship however

1 64-65 mustang under dash ac unit < universal > you simpy run the lines to this and use it with any universal ac compresor condensor and dryer then run 12 volts to it fan and temp controll is built into it 300 shiped

1 gm 4l60 non lockup 3200 tci torque converter used 400 miles was to lose for customer 250 shiped

TRZ four piston aluminum road race calipers used front and rear set
universal build your own huge brake kit for use with 14 to 15 inch rotors
calipers work perfect no pads 450 shiped

2 351 windsor canton 7 quart oil pan kits with pickup 100 shiped both sold

1 used in dash 160 mph auto meter ultralight speedo 310 miles showin on odometer 100 shiped

2 - 255 frame rail mounted fuel pump kits 100 shiped both sold

3 - fuel air spark 36 pound injectors 300 shiped

4 - fuel air spark 65 pound injectors 300 shiped

2 gm msd alternator mount kit for the msd billet alternators 45 shiped

1 msd gm distributor hold down 30 shiped

1 13 inch baer universal hat eradispeed rotor 50 shiped

1 05 mustang gt-500 big brake kit 995 shiped

1 set black suede 71 challenger armest 50 shiped

15 - 1967-68 mustang aluminum brushed dash inserts 20 each + 2.95 shipping

1 msd 2345 dual sync chevy ditributor < allows for sequntial efi without a crank triger > 300 shipped

70-71 cuda bumper brackets used cleaned up and painted black 75 + shipping due to weight and size < dam cudas are huge in every way >

1 set weld billet 18x9 wheels with 245-40-17 tires less then 400 miles for early chevy car patern came off the unique auto chevy hhr show car.

bolt patern is 5 by 4.75 with 4 and 1/2 back space 2000.00

1 acell dfi gen 7 77021 fuel injection system complete new in box .. 1600.00 shiped

pics of most of everything can be seen here

http://s76.photobucket.com/albums/j10/8urls1/auction%20sutf/




just pm or email [email protected] for pics

[bigtyme1]

Need a price please.

1 gt350-500 mustang moto lita billet/wood steering wheel 15 inch diameter

[sacarguy]

I will put prices up for everything im sorry for not having them yet im geting the list together now this is all stuff bought from a bankrupcy auction.


asking 175 for the wheel its a authentic british moto lita from the same company who built the original gt-500 wheels

[bucks69]

1 detroit speed complete rs electric headlight conversion

I call DIBS pending price of item

[mark smith]

interested in the door lock, trunk lock, and glove box lock with keys.will watch for post with price.

[Project_Gotham]

His name is Dean, I already bought the Baer 6-piston caliper

[sacarguy]

sent pms with pricings.

[aany001]

I would like a price on the RS electric converson kit please.
thanks
Steve

[dabuickman]

wilwood billet mastercylinder part number and price? Thanks

[dagger]

PM sent about MSD 6BTM.

[awr68]

Are you sure that's a 345 tire on a 9" wheel?

Oh, and we need individual prices asap per forum rules...thanks!!

[bigtyme1]

1 90 mm fast ls-1 throttle body CHROMED

price please

[sacarguy]

Are you sure that's a 345 tire on a 9" wheel?

Oh, and we need individual prices asap per forum rules...thanks!!

omg thank you no its a 245 sorry for the typo

im working hard on it puting prices up partialy today

[sacarguy]

1 90 mm fast ls-1 throttle body CHROMED

price please
295 shiped

[bigtyme1]

I will put prices up for everything im sorry for not having them yet im geting the list together now this is all stuff bought from a bankrupcy auction.


asking 175 for the wheel its a authentic british moto lita from the same company who built the original gt-500 wheels

did you get the adapter and horn button?

[sacarguy]

this wheel doesnt use a daptor they are direct replacment for the gt-500 and gt-350 and came as such .. it wasnt a universal wheel so there was no adaptor

if you want to use them in another car they will accept any of the universal adaptors and buttons or you can purchased the install kit for other cars from moto lita

this is a 250 dollar wheel and its brand new

[simbad's68]

PM Sent!!

[Loneman]

PM sent about MSD 6 AL,Console lense,KN air filter,Console ash tray,door and trunk lock set,and Wilwood billet mastercylinder.

[sacarguy]

updating list with sold items .

[oorange67]

PM sent

[DOOM]

I'll take ''all'' RS headlamp parts PM SENT ........

[mightymouse7]

I want The DES motors/brackets/adj. rod 100.00
full set of keys 40.00
RS headlight door bumpers 5.00
68 Console hardware kit 5.00
Are the parts I requested available? You do not have them marked as sold or pending? I want to send MO out but need confirmation that you have them available.

[Loneman]

Your PM box is full we need a way to comunicate.

[kaptainkw]

I see, in fact I have bid on some of these exact same items on eBay from the same seller. What gives? Do you have multiple items and are just spreading them around or is someone on this forum or eBay just going to be told they are out of luck??? Please tell me it is the prior.

Check here for the eBay listings: http://motors.search.ebay.com/_W0QQsassZtealsaleen

:mad:

[sacarguy]

ok cleaned out inbox

making a list of items claimed for in order claimed for from pms today will post who got what today so far.

i have this list on five forums so please bear with me

plus i have several ebay auctions for some items.

I am a 100 percent for real and honest seller NOTICE the numbers before the items ? that is how many i have of each .. if i listed a item here and on ebay its because i had multiples.

for example i had multiple rs head light kits i listed one here and one on ebay < the one here has sold already >

there was only a few items i listed on ebay that i listed here also that i only had one of and that was the brake parts box and thebare six piston caliper and as soon as i had a bid on ebay i removed it from the list here.

If i have a item on ebay and it gets a bid i update it as sold here simple as that.. if i sell it here and there are no bids on ebay i remove the listing if your waiting to the last minit to get in and hopefully steal a item at basement price thats the risk you take simple as that if you bid the minimum on the starting day of a 7 day auction i will STILL list that item as sold here even if offered the full asking price.

if you would like proof of that check my ebay auction history i removed the baer six piston caliper after a board member bought it off here before it had any bids.

I own a legitimat buisness a performance shop and i do not scam people.

[sacarguy]

ok for those who asked im goign through my key sets etc right now for a more detailed listing of the small camaro stuff

i was working off a list given me by one of my guys who does chevy stuff i have dug through and verified everything to be this list as to what i have.

I know there were several peopel interested in keys and locks so here is the list if you had pmed me before on th ekeys and locks please get back to me and ill make sure to check them off and box them up for you.

i have
4 inition switches no key tumblers in them 10
1 ignition switch with key and tumbler 15
7 chrome new repro ignition trem bezle 3.00
4 reproduction stereo fader base treble adjuster rings 2.00
1 repdocution cigaret lighter 2.00
5 silver and black headlight pull knobs 5.00
1 all chrome head light pull knob 7.50
5 head lamp switch nut 2.00


4 68 69 console hardware kit 7.50
6 ashtray spring kit 2.00
4 inner window felt guides 2.00
1 courtesy lamp brakets 2.00
3 rs headlight door bumper kits 3.00

3 console stoper kit 5.00
3 console hinges 10.00
2 headlamp retainign ring screw kit < the litle silver ones > 3.00
3 headlamp scrw kit < the black oxide ones > 3.00
5 rs headlight door bushing kits does both lights 10.00
1 tailight studd and nut set 3.00


ok now to the locks
2 matched sets door and glove box 35 for set
1 67-69 turnk lock w key original style 15
1 glove box key and lock 10
2 68 original style key ignition 10
1 67-69 ignition key tumbler with key late model style key 15

4 pairs of inner hinges sold as left and right pairs 30.00 pair

2 firewall carpet gaurds 18.00 each

1 67-68 camaro parking light pig tail 5.00
4 repro camaro consol harnesses with manual trans 4.00
3 68 69 camaro consol light lense 4.00
1 67 rs motor nut and drive 2.00
1 glove box bumper set 4.00
2 console stopers / bumpers 4.00
1 package tray cover black 15.00
1 interor to trunk seperator panel and insulation 10.00
1 68-69 vert top boot with clips 50.00

there that prety much sums up the small camaro parts

as i said i cleared my pm box please as i filled it in two days i had so many replies and it was very hard to keep track of if you were interested in anything re pm me with a list and i will fill the orders as soona s iget them and list off whats sold on the small trim stuff. and im updateing my main list with thats no longer available.

its very hard for me to keep track of all this as i have multiple boards going plus runing my buisness each day but if i say a item is yours it IS YOURS

[mightymouse7]

its very hard for me to keep track of all this as i have multiple boards going plus runing my buisness each day but if i say a item is yours it IS YOURS


yeah, whatever

[sacarguy]

pming me asking for pricing does not mean you have the item if someone else calls with a credit card before you give a firm comitment to buy they get the item that simple.

and just because you pm me and say hey i want xx item ill take it also does not mean that i dont have pm prior to yours with the same request and if they are ready to pay it goes to the first to ask.

I'm not trying to cause a bidding war the prices are set and im simply filling orders in the order i get them.

for those who purchased items already

you will recieve your tracking numbers for ups from me on monday.

Sorry for any confusion and I am trying to deal with everyone fairly and in order.