Killer set of LS1 heads FS

[gearheads78]

Fresh from the machine shop set of hand ported heads by Trevor Johnson Racing Heads (Same guy that does lots of work for Hennesy Motorsports) These are not some mass produced lets see how many sets we can throw out this week type of place. I have seen some of the advertised heads on his bench and lets just say not all of them meet the numbers stated. I am selling off lots of nice parts to get out of debt and then start on the Cutlass.

These heads on a stock cube LS1 in a 3600 lb street strip car on tiny drag radials was running 7.1's-7.2's @96 MPH. The cam was a mild 228/234 607/598 on 110 the the combo was far from optimized

The cambers are milled to 60CC. These are not just hogged out. Lots of time spent to keep the velosity up. Flow sheet in picture below. In slightly lighter protouring car you will have a rocketship

$1040.00 shipped $1000.00 picked up in DFW. You will not be disappointed.
Richard 214-793-0029
http://www.deadzoom.com/member/gearheads78/forsale/ls1heads001.jpg

http://www.deadzoom.com/member/gearheads78/forsale/ls1heads002.jpg

http://www.deadzoom.com/member/gearheads78/forsale/ls1heads003.jpg

http://www.deadzoom.com/member/gearheads78/forsale/ls1heads004.jpg

http://www.deadzoom.com/member/gearheads78/forsale/ls1heads007.jpg

[gearheads78]

One more bump before EBAY. They need a new home. This is a lot less than you would have to pay for a set of this quality. Reasonable offers will be considered.

[gearheads78]

price drop before EBAY auction to start Sunday night

[hellrace]

why selling them if they are so good, and after the price dropped its now ?
:thumbsup:

[gearheads78]

Because I am parting out my 98 Trans Am street / strip car. I want to build my Cutlass in a bad way and until I can raise some cash I can't start. No matter how hard I try these won't bolt on to a 455 Olds :D

[gearheads78]

sold...