Onebad78ta

[ONEBAD78TA]

Here are a few pics before the car was moved to metalworks classics to complete the car,It took a while to get the hack working on it to release the car but at least it's finally out and can get some quality work done.i am expecting the motor from BUTLER PERFORMANCE in a couple weeks and should get some dyno pulls on video so that should be cool,,,,,I don't mean to complain on here but sometimes I need to vent and ask for opinions on time to do some of the fab work because I know when I'm being scammed like the 36 hours he charged to do the work you see on the roll cage,,he said it had nascar side bars and an X brace in the back and it's not there WTF,,,PLUS NOT 1 tube is welded,,I'm sure some of you guys are capable of doing a complete cage install in 36 hours or am I wrong,,,this is where opinions would be appriciated

[streetbird]

clean car, will follow this one

[ONEBAD78TA]

Thanks,,,the nice stuff is comming soon

[omiotek]

nascar door bars? i think not..... His cage does not look all that bad though unless the pictures make it look better then it really is. Does suck to hear he charged you what he did.

Look forward to seeing your build. Glad to see you getting it in the right hands.

[ONEBAD78TA]

Thanks again ,,yea All I had seen was his bill with him saying he did nascar sidebars and an X brace in the rear and as you can see it's not there,,,So I about went through the roof when metalworks posted pics of my car on there sight and I saw that not only did he not do the side bars or X brace but he only tacked the cage and didn't do one weld,,,I paid over 3 thousand dollars for this so I'm pretty upset,,,BUT at least it's in good hands now like you said,,and it should be pretty smooth from now on.

[WSSix]

Whose rear frame rails are those? Maybe it's the angles of the picture but they don't look like they kick up high enough to bring the car down much any more. They actually look like they are lower than the factory frame rails.