1969 Camaro Part Deaux

[Zoomin]

Got the tubs in place



And with that done, we put the wheels in place so we could measure for the Quick Performance 9" rear. Got that order in, should have it next week.

[JKnight]

Looks fantastic! Nice job on the tubs and wheel selection.

[slenning]

Nice work so far! Love those wheels!!

[FaBrycation]

Nice work!

[Zoomin]

Originally Posted by JKnight

Looks fantastic! Nice job on the tubs and wheel selection.

Originally Posted by slenning

Nice work so far! Love those wheels!!

Originally Posted by FaBrycation

Nice work!

Just another Camaro, but hey it's mine! Thanks for chiming in.

[tubbed69]

very nice work,really like the car

[Zoomin]

Originally Posted by tubbed69

very nice work,really like the car

Thanks Jeff, if it turns out half as good as yours, I'll be thrilled!

Today Kyle's turned his attention to the front end. The front fender is off to have the paint repaired which makes this the perfect time to pull the suspension and engine. The engine is going to be repainted and the RideTech TruTurn system installed.





The brake booster and master are going to be replaced with a manual Wilwood unit.





Coil overs, Strong Arms, drop spindles installed.

[Zoomin]

Here's a look at the brains of the TruTurn setup. The center link gets a brace that relocates the tie rods to eliminate bump steer, in conjunction with special steering arms and taller spindles. Really nice pieces.






Here's a look at the side with the fender still on it. This isn't ride height, the lift won't go any lower.

[califconstruct]

.
Good stuff on that tubbing, car is looking good!

.

[Zoomin]

Originally Posted by califconstruct

.
Good stuff on that tubbing, car is looking good!

.

Thanks Art!

I read through Joan's build thread and I gotta hand it to you - you've got major determination.