Shop location I worked at closed and then reopened causing a hiatus from the project and almost abandoning it entirely. But now finally back into it. Ordered the uniballs early this week which arrived today. Measured them after work and input into solidworks and finished my control arm fixtures. Sending these out to get laser cut tomorrow. I still need to remove the balljoints from the knuckles and modify them for use with my control arms.
Ive also been rethinking my drivetrain choice and doing something a little different and maybe going with the the 5.0l v10 s85 bmw motor. Could work out great but then again i could be plagued with the semi common bearing issue, etc.... I try not to get too caught up with all the forum horror stories of the motors. Some people love em, some people hate em. Those motors sound great and it isnt an ls motor.
Control arm fixtures -