crank case ventilation. - Page 2 - Lateral-g Forums

Grnova · #11 03-22-2015, 10:46 PM

Quote:

Originally Posted by GregWeld

That sounds like something a girl would say.... That's not a "problem" - that's just an item that could be easily rectified with a bit of hot rodding... You know - like taking some stuff apart and adding whatever is needed! LOL

Thanks I know all about taking things apart and putting it back together my way! Lol

**GregWeld** · #12 03-22-2015, 10:51 PM

Quote:

Originally Posted by waynieZ

Weld if your ever near Mass we got to meet up..................

HAHAHAHAHAHA DEAL!!

Grnova · #13 03-24-2015, 03:46 PM

So I have read a lot about crankcase ventilation and decided to try venting both valve covers to filtered catch cans. Hope this works!

**GregWeld** · #14 03-24-2015, 05:42 PM

Quote:

Originally Posted by Grnova

So I have read a lot about crankcase ventilation and decided to try venting both valve covers to filtered catch cans. Hope this works!

That's the direction I'd go.... Try to use -12 lines and fittings if you can. Let the air out!!

DO NOT oil the little K&N style filter! It needs to flow freely.

Grnova · #15 03-26-2015, 05:51 PM

So to update I pulled the trigger and ordered a Monster can fromhttp://www.rxperformanceproducts.com RX Performance. Tom and Tracy are great guys to work with and came up with a kit specifically for my application. They also have a clean sideswipe raptor that goes in place of the oil fill cap on the valve cover and my valve covers being from Holley they are making one that will screw into the Holley style hole. I will continue as soon as the kit arrives.

Grnova · #16 04-24-2015, 02:04 PM

Got the catch can yesterday here is what I came up with... thoughts?

**canrc** · #17 04-27-2015, 02:16 PM

Hey Tim,

I have the same setup as you and I have attached an image on what I had done -- I have since switched to a Holley Dominator ECU and don't have the MAF but with the roots style blower I didn't have to relocate any of my lines, I also ended up running a -8 for the clean side separator.

The tank works great! good choice.

Raj

Grnova · #18 04-27-2015, 03:02 PM

Thanks for the diagram. I'm glad this is the same way I have mine.

What type of salve covers are you running, I have the Holley valve covers and am waiting for the adapter for the clean side separator to come in.

**canrc** · #19 04-27-2015, 04:43 PM

I have a set of the Wegner Billet Valve covers, I did have to weld in a baffles onthe inside of the valve covers but they work great.