New lists!
Modify Harness: I went with a new harness from PSI (
http://www.PSIConversion.com ). It was around the same price as many charge to modify a harness and it gets you all new connectors. Also, the harness has a good 2' of length added to allow you to install the ECM and TCM inside the vehicle.
Cruise Control: Because I am running a Gen IV engine, the GM cruise control cannot be easily adapted (it's in the BCM, and not the ECM as with earlier LS series engines). I went with a system from Spanky's Rod Shop (
http://www.spankysrodshop.net/ ) which interrupts the circuit between the gas pedal and ECM to implement its functions. Apparently it can be programmed to work with any cruise control buttons, so I had them program it to work with the factory Jeep/GM column switch.
Fan Controller: Painless #30141, F5 Single 70 Amp Fan PWM Controller. This will soft-start the fan and bring it to 50% power at whatever "on" temperature you set. As the vehicle's temperature rises, the unit increases fan speed. It also bypasses the temperature setting when you turn the A/C on, and allows a settable speed at which it no longer turns on the fan. I will use this feature to run the low speed on my Lincoln Mark VIII fan. The ECM will turn on the high speed feature of the fan if the engine gets to the higher temperature the ECM is set at. This gives me a redundant system to ensure the engine runs nice and cool.
Keyless Entry: I went with a system by AutoLoc (
http://www.autoloc.com ). I chose them because they have a flip-key style remote that works with their system. I'll be modifying a key and maybe the ignition cylinder to use this.
Remote Start: I know, such a sissy sort of thing, right? Well, my wife has MS, and heat, as she says, is the enemy. Being able to remotely start the vehicle and allow the interior to cool down will be great for her and a luxury for me. I went with an Omega/Excalibur unit.
Battery Isolator: I plan on running at least one deep cycle battery besides the normal "starting" battery. This is to go along with all the other "stuff" I have added, along with the inverter I plan on installing. I am using a "smart isolator" by Intellitec.
Battery Charger: I will be mounting a Battery Tender on board.
Stereo/Navigation: Kenwood DNX6140. A double DIN stereo/cd player with iPod control and Garmin GPS.
CB: Galaxy DX949 w/SSB. The unit is too deep to mount how I wanted, so I am extending the wires to the faceplate so I can remote mount the body and install the face in my dash.
Scanner: Uniden BCT15X TrunkTracker III... yeah, I don't know why, I just had to have one.
As for progress...
Over the weekend I tried out the simulated "brushed aluminum" vinyl I purchased. Great stuff! (3M DiNoc). I do need to use the adhesive promoter/primer 3M sells, and so have ordered that. I'll post pics of the finished dash insert once I get the primer and redo it.
I also began running the Engine Management harness. So far, I have only run into one difficulty, the cam sensor connector is different from my engine's. I'll contact PSI as soon as I have checked all the other connectors, but I imagine I will just need to swap out the connector.
Until next time!