Quote:
Originally Posted by Chad-1stGen
I planned to leave the sheet metal intact. However I'm open to advice on how to do it. I would love to be able to roll the new clip with motor and trans bolted up but am not sure how I'd lift the body high enough to clear it while supporting everything properly? Any ideas? Without the motor it will be easy enough. It's the with motor part that is tougher.
|
Take the front clip off as a unit (the sheet metal). Much easier that way.
Roll the old frame out,roll the new frame in, bolt the front clip back on. No lifting of the body,less chance for accidents or damage and its only a little extra work.