View Single Post
  #4  
Old 04-05-2005, 10:46 PM
Gmac454's Avatar
Gmac454 Gmac454 is offline
Junior Member
 
Join Date: Dec 2004
Location: Minnesota
Posts: 12
Thanks: 0
Thanked 0 Times in 0 Posts
Default that is what i thought

the block is newly bored and decked and trued. the pistons are new as are the rings. it only has about 40 miles on it. but i have never had this much crank pressure ever. I was hoping the rings would seat after i put a few miles on it. do you think if i did a compression test it would give me an indication of what is up. you know do a dry pump and then poor some oil on the seal the rings and do a wet pump ??? what do you think. i appreciate you guys mulling this over thanks!
Reply With Quote