View Single Post
  #3  
Old 12-09-2010, 12:03 PM
Mikamaro's Avatar
Mikamaro Mikamaro is offline
Member
 
Join Date: Dec 2005
Posts: 25
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Thanks, my estimates are starting to creep up towards $1K too unfortunately. Between needing new axle to go with the ford ends and shipping this is getting too expensive for my budget. Apparently I can respline my axles but they are not designed for the press-on bearing and will not work with the ford housing end.

I will just respline my c-clip axles at Moser and narrow the rear locally. Can the tubes simply be taken out, cut, and pressed back in? I plan on having the tubes fully welded to the housing anyway.

Mike
Reply With Quote