View Single Post
  #7  
Old 06-29-2011, 02:05 PM
fletcherscustoms fletcherscustoms is offline
Senior Member
 
Join Date: Dec 2005
Posts: 986
Thanks: 0
Thanked 0 Times in 0 Posts
Default

My body guy Josh (joshatfletchers) has been on "rust" attack mode the last couple of days. almost 5G's of sheetmetal showed up from Danchuk and he has been on the attack. Last night he finished up the install of the rear trunk section, which included a rear trunk floor patch panel, a under floor brace piece, and a the lower section of the deck lid opening. All of these panels were extremly rusted out. If I wouldn't have seen the reinforcement piece shown in the Danchuk catalog I would have no idea it actually was installed in the car, there wasn't a piece of it left. Just in this area alone, 17.6 pounds of 1970's bondo was removed in chunks as thick at 3". Body guys were sculptors back then



__________________
Chad Fletcher
Fletcher's Customs and Speed
229-221-4690
[email protected]
Reply With Quote