View Single Post
  #193  
Old 02-24-2012, 07:59 PM
black2002ls black2002ls is offline
Senior Member
 
Join Date: May 2005
Location: greenville, tx
Posts: 675
Thanks: 0
Thanked 1 Time in 1 Post
Default

I'm not sure if I will have the hoops machined or not. That was the original intent. My plan is to use the printed pieces to get the suspension set up, as well as determine the backspacing. Once all of that is taken care of, I will decide whether to have the "sleeves" machined or not. I've got a few machinist friends so that may happen. As for the tires, at this point, my plan is to model them, have them printed, and then molded and cast in rubber. The only problem is $$$
__________________
1/12th scale 1969 Sunset Orange Metallic Camaro Pro Touring Style>>
Progress Thread

Artwork Page
Reply With Quote