View Full Version : FI for olds 455
10-03-2006, 06:56 PM
does anyone know of a kit out or a bolt on intake for a olds 455? i know you can retrofit it to a intake but i wondered if there was one i could just buy and stick on. also if anyone knows the cost that would rock. i want it to clear a stock ram air hood also. thanks.
10-03-2006, 07:51 PM
I don't know of an intake available, but keep in mind that most throttle bodies are between 0.25" and 1.25" shorter than the factory Q-jet (which was 3.25" base-to-air cleaner flange). In other words, you can tolerate a little taller intake.
10-03-2006, 10:46 PM
ah good imput, thanks :)
10-04-2006, 08:07 PM
http://www.mass-floefi.com/mass-flo.html not sure if this is what you want but take a look
10-04-2006, 09:27 PM
Call Edelbrock, they have a lot of experiance with the olds 455.
Check out November 2006 CarCraft. (Page 38) Thay have a bolt together Olds 455 build. It is made for a Cutless. Should do high 11's @ about 115 in a 3800 pound car.
500 hp at 5400 rpm
570 ft pounds of torque at 4000 rpm's!!!
Hope this helps.
vBulletin® v3.6.4, Copyright ©2000-2014, Jelsoft Enterprises Ltd.